Air Conditioner Heat Exchanger Production Equipment: Planning the Line

For air conditioner heat exchanger production, equipment selection should start from the product drawing, not from a machine list. A condenser and an evaporator may both use fins and copper tubes, but the fin pattern, tube pitch, coil size and production rhythm can be different.

The usual production flow

A typical factory will first make fins with a Fin Pres Hattı and custom Fin Die. Copper tubes are then straightened, cut and bent. After fin and tube assembly, the tubes are expanded so the coil has stable heat transfer performance.

Key equipment to review

• Fin pres hattı: for fin punching, collar forming and louver forming.
• Fin die: the tooling that controls fin pattern, tube pitch and collar quality.
• Tube processing equipment: for tube straightening, cutting and bending.
• Tube expander: for expanding tubes into the fin pack after assembly.

Some buyers only ask for a single machine at first. That is fine, but if the goal is a complete air conditioner heat exchanger production line, the machines should be discussed as one workflow. Otherwise, one process may become the bottleneck later.

Useful information for planning

Prepare the condenser or evaporator drawing, tube diameter, fin dimensions, fin pitch, material thickness, expected daily output, workshop layout and voltage. These details help SINOAK suggest a more realistic equipment configuration instead of a generic quotation.

FAQ

Can the same equipment make condenser and evaporator coils?

Sometimes yes, but it depends on the product drawings, fin die, tube layout and expansion requirements.

Which machine should be selected first?

For fin-and-tube heat exchangers, start with the fin drawing and fin die requirement, then match the fin press and downstream tube equipment.

Can SINOAK help plan the full workflow?

Yes. SINOAK can review drawings, target output and workshop layout before suggesting equipment.